The Garagistic Poly E36 subframe bushings are labeled as top front, top rear, lower front, and lower rear. There are two of each. Front bushings will have smaller bolt holes, while the rear bushings will have larger bolt holes. The four bottom bushings are identical in appearance aside from the difference in bolt hole sizes. Delrin subframe bushings are not labeled but can be identified by the bolt hole size and face design.
1) Position the subframe as if it were installed in the car and stand at the rear of the subframe, sway bar tabs close to you
2) Grease the four top bushings and use a mallet to tap them in
3) Flip the subframe over, grease the four lower bushings and use a mallet to tap them in
*Delrin bushings may need to be pressed in
*Instructions are intended to provide general information only. We recommend a professional automotive technician install any of our products.