BMW THROTTLE CABLE BUSHINGS - BILLET ALUMINUM

With age, the factory throttle cable bushing gets soft and spongy, cracking and forcing the throttle cable to sag. Throttle response gets worse since the cable must first straighten up before it starts to move the throttle plate. The EMC (engine management computer ) sets the engine parameters accordingly. Replacing the worn bushings with the Billet Aluminum throttle cable bushings eliminate cable sag and restores the EMC parameters to give a crisp throttle response. The throttle cable bushings kit includes 2 Billet Aluminum Throttle Cable Bushings, 2 Snap Rings. Instructions can be found here.

Important: Does Not Fit E30/E28 M20 Cars or the 750 or 850.

WILL THESE THROTTLE CABLE BUSHINGS FIT MY BMW?

These throttle cable bushings are designed to fit the following Years & Models

E39 and E38 (1993 to 1998) 528, 530, 540, 740, and 840 without ETK ( Electronic Throttle Controller )M60 and M62 motors
E36 and E34 (1990 to 1999) M3, M5, 325, 328, 525, 528, 535, 735
M20, M42, M30, S14, S50, S52, M52, or M50 motors
E34 M20 cars
E28s with M30s only
Sorry, does NOT work on the 750, 850, or E30/E28 M20 cars

INSTRUCTIONS

Quick Tip: Its easier to replace the bushings if you remove the throttle body from the intake manifold

Step 1: Unhook the throttle cable from the throttle body

Step 2: Unscrew the throttle cable from the factory bushing and carefully cut the old bushing off the cable

Step 3: Put the throttle cable through the slot on the aluminum bushing.

Step 4: Put the aluminum bushing through the throttle cable bushing bracket and secure it with the snap-ring provided

Step 5: Reinstall the throttle cable back on the throttle body and install it back on the intake manifold.

Step 6: Adjust the tension on the throttle cable till it's tight but still allows the throttle body to close without interference.