E36 STAINLESS STEEL COMPLETE 6 BRAKE LINE KIT

Restore a vital safety item on your E36! This is by far the best bang for buck mod for your E36 braking system. Rubber lines are cracking by this age in the E36 life. Even when new, the stock rubber expands when you press the brake pedal, they expand under the normal pressure of use. This expansion of the brake line negatively affects the brake caliper piston travel and makes for mushy pedal feedback. Stainless steel brake lines improve braking performance and stiffen your brake pedal for a more direct feel.

USA made and DOT compliant. Those who have upgraded their brakes on their BMW E36 know the drastic difference and support they provide! If you've driven a stock E36, you know just know unpredictable they tend to be on the track. Stainless steel brake lines have long since been proclaimed by many an enthusiast as the most cost-efficient upgrade for your BMW E36 and many other BMW's. This E36 stainless steel brake line kit is for better brake pedal feel, modulation, firmer pedal, and better braking response. Those who track know the severity and sheer importance of braking power. The irony of having to go slower - brake quicker to get better track times is lost on many.

Brake Fluid: We recommend ATE Original TYP 200 DOT4 for its dry boiling point of at least 536°F and wet boiling point of at least 374°F. Readily available here: https://amzn.to/40rXHYX

BENEFITS OF STAINLESS STEEL BRAKE LINES

Inner Teflon line is covered with woven stainless steel braid that will not expand under pressure. The advantages include better brake pedal feedback and a firmer pedal, along with superior brake modulation. The results will be immediate! Not to mention they are fully compliant with DOT Standards (MVSS-1006), have a lifetime warranty, and are burst-tested to 6000psi ( the maximum tested pressure from a BMW braking system is 1200psi). Unlike other brands out there, our brake lines have Teflon inner line covered with a woven layer of stainless steel and covered in an abrasion-resistant material (plastic covering). We even have plastic end pieces so there are no exposed steel fibers. Be sure to have a qualified installer to make sure they are responsible for correct fitting and bleeding procedures as recommended by BMW. As brake line installation is a safety-related item, the installer assumes all responsibilities and risks associated with brake line replacement.

DOES THIS FIT MY BMW E36?

• These lines fit all 1992-1998 3 series E36 models with dual rear brake lines*
• Models include E36 325i, 325is, 328i, 328is, 318i, 318is, 318ti Compact, and M3
• DOES NOT FIT 1998-1999 E36 models with single-piece rear lines.

If you have any questions regarding the fitment of your BMW E36, please check your VIN on realoem.com or contact us!